This fully wired harness has a pull up switch on the volume pot to put dual coil pickups in series.This works well with MM and other dual coil pickups. This harness has one volume and one tone pot, with a .047uf Mallory 150 capacitor.

All pots are 250K. I can do these in 500K as well. Let me know if you need a 500K version.

You can connect the pickup leads with the included wire nuts, or solder the pickup leads and insulate with the included heat shrink tubing.

The pull up switching pot is only available in split shaft. You can choose split or solid shaft for the tone pot.

I will use standard P bass spacing unless you tell me different. I always provide a little extra length on all wires in case it's needed.

The Mallory 150 caps that I use are exactly the same inside and actually cost me more than orange drops.
The only thing that is different about orange drops is that they have a waterproof coating.
Hopefully you don't need that...

Leave any additional instructions such as special spacing requirements in the comment box at checkout.